Working on a DLP projector, no light. I don't measure any voltage going to a lamp socket with lamp disconected. I looked for both AC and DC. Looks like there is a ahole board for the supply with OSRAM parts. Anything else to check ?
greg
You could find the signal line that triggers the lamp driver to turn the lamp on and make sure it's changing states when the lamp should light.
Be *very* careful probing the lamp sockets on these, a properly working driver will supply pulses of several kilovolts to ignite the arc in the lamp. You can easily fry your meter, or worse.
The drivers are essentially switchmode power supplies configured to supply a constant current rather than a constant voltage. Standard SMPS troubleshooting applies, taking into account the greater than usual high voltage hazard.
I used an old analog meter. There is a LED lamp on indicatior on the top of the unit, and it does go on. Evn if I just had a bad lamp, I would imagine there would still be a clicking or visable arc around the lamp. $435 for a new lamp, wow.
greg
there would
Ha, Sounds like you have an RCA 61 inch? , that is what my DLP is. and it cost that much for a replacement lamp assembly.. Your problem sounds like a ballast/driver problem.
-- http://webpages.charter.net/jamie_5"
Common causes are the lamp failing, and or the lamp power supply failing. Servicing the power supply is not easy. It will need a proper test load, or the lamp to load it for taking measurements.
There are safely issues involved when working on these. The factory service tech will start by changing the supply if a new lamp does not work properly.
-- JANA _____
Viewsonic, and I have to come up with a power cord.
greg
I took the thing apart. One of the worst assemblies I have ever seen. Seems I can't find much info on Osram stuff. It looks like the whole power supply is by Osram. There is a block on the board which runs the lamp, designed specifically for that lamp. There is some detail in the wiring on the block but its not entirely obvious. The block runs on AC but I was going to plug it into AC, but the frequency is likely to be higher than 60 HZ.
greg
I posted a reply here and it vapourised. Then it wouldnt let me add a lengthy reply to another post, what is usenet up to? Find out from the customer if he saw a lamp timer warning before this happened. If so u need to find the lamp timer reset sequence of key presses at power up (from the op manual). Do NOT send the set back with the old lamp after resetting timer, it will implode liberating noxious gasses.
I was guessing the lamp "on" was OK since the lamp LED came on.
greg
Oops , sorry, my bad.Have you checked the thermal cut off on the lamp housing?
No, but I looked for lamp voltage with an old meter.
greg
DC avlbl in ballast?
The Osram block is driven by AC. I have not measured anything yet on the power board. There looks to be an AC generator which feeds the output block.
greg
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.