I guessed that it was a 6.8vz but I can't find any zeners that use this type of marking.
Thanks in advance
--------------= Posted using GrabIt =----------------
------= Binary Usenet downloading made easy =---------
-= Get GrabIt for free from
Probably is a transistor... Test it with the tester in diode mode to find base-collector-emitter.
Bye!
"pbabin" ha scritto nel messaggio news: snipped-for-privacy@giganews.com...
It is a transistor. Use the site below to cross reference! Rono.
type of marking.
I'm fairly sure it's a diode. There's another on the board and it checks to be a diode. The board layout has only 2 connected pads. If it were larger, I'd remove the other from the board and apply voltage to it to see if it had a breakdown voltage near 6.8v but the physical size would make it difficult.
If it is a diode, it is most likely as you suspect a 6.8Vz. Looking at the SOD-80 diode markings, to looks to be a corrupt form of mark (6Y8 but 6.8Y) for a 6.8Vz.
To confuse matters there is also a transistor 68Y but without the decimal point and it's in the SOT-89 package. I see a load of diodes in this same package, they use ether two pins only or have the opposite two pins tied together.
Wes.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required