Turned on my TV the other day and was missing video. Can still change channels, hear audio, see the raster lines (I think), and go through the menus. But I can't get video from the coax, s-vid, or rca inputs.
I saw where a couple of other people had the same problem a while back and it was mentioned to "clean the glue off L14401 and resolder it." But it didn't look like that solved their problem.
Any ideas?
Thanks, Logan
Check for a bad connection on Connector P103 pin # 4, also check R14119 (15 K 2 watts).
GNK
AgapeDisciple wrote:
Thanks GNK! I'll check it out tonite.
BTW, did you have this same problem?
Logan
gnk wrote:
I resoldered P103 Pin #4 and checked R14119 = 13K ohms. (Is that too low?) I also checked the error codes. Here's what came up:
1 - 3 | 03 | 12.0V run fault | 12.0V source is failing. 2 - 3 | 03 | 12.0V run fault | 12.0V source is failing. 3 - 44 | 2C | F2 PIP module error | F2PIP fails to acknowledge.And I resoldered L14401.
Any more ideas?
Logan
The only other information I can find for this chassis with similar problems is to check for a Leaky C14112, .01/1kv, causing R14119 to overheat.
Good luck. GNK
AgapeDisciple wrote:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required