Hi,
I am using ISE5.1i...XST synthesis tool.
At the end of synthesis, XST generates defualt timing report for 1 or
How can i generate a timing report after synthesis for more than 100 paths?
ie., as like .twr after Place and route.
And How can i measure the time dealy between 2 specific points... Points could be FF,mux or any logic
Thanks in advance.
Regards, Muthu
Its all in the options.
Right Click "Post-PAR Static Timing" and choose your report options.
For analyzing specific paths - launch the "Timing Analyzer".
Its much better in 6.1!
Post PAR can only be run with the Map results Right. But i need to take the report from XST itself?
XST only does a summary. You will have to run map and trce to get 100+ paths.
Steve
Have something to add? Share your thoughts — no account required.
Ask the community — no account required