programming the mach231

Apr 30, 2004 2 Replies
N

I have a bunch of free mach231 chips but I can't find any information about how to program them. I have gathered from the web that they are not JTAG. The datasheet does not explain how to program the chip. I am planning on constructing a programmer but there is not a lot of information about how to do this. The closest thing I have found is some information and schematics showing how to build the expro-60. Any ideas or information would be appreciated.



Nathan



change tepid to hot to reach me by e-mail


Vote
Twitter Facebook LinkedIn
G

This is a problem with most programmable chips these days. The manufacturers normally supply the programming data to the major programmer manufacturers (Data I/O, BP, etc.) and don't bother to put it in the databook unless the part is in-system programmable.

If you can get the information at all, you'll do best to contact Lattice Semiconductor directly.

Good Luck

Gabor

Vote
Twitter Facebook LinkedIn
N

snipped-for-privacy@alacron.com (Gabor Szakacs) wrote in news: snipped-for-privacy@posting.google.com:

Lattice just says go to a third-party programmer company for any programming support. Does anyone work for Lattice or have a friend at Lattice who could get this kind of info?

Nathan

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required