ISE:Simulation

Hi, I have a process in my code that is decides if enable pin of a counter is high or low. When i start my simulation the process is triggered by one of the signals in the sensitivity list and the signal goes to high, but it doesn't get triggered when the same signal in the sensitivity list gets the triggering value again or the enable signal never goes to again...

Any ideas please ...

Reply to
ANIL CELEBI
Loading thread data ...

This would be much easier if you would show us the code.

--
Joe Samson
Pixel Velocity
Reply to
Joseph Samson

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.