I noticed that the CoolRunner (XPLA3) sets all of the pins (at least the ones I can monitor) high during in system programming. Is there a way (programming file) to hold the pins low during programming?
Thanks, Eli
I noticed that the CoolRunner (XPLA3) sets all of the pins (at least the ones I can monitor) high during in system programming. Is there a way (programming file) to hold the pins low during programming?
Thanks, Eli
Eli Hughes schrieb:
Those are weak pull-ups.
Regards Falk
Have something to add? Share your thoughts — no account required.
Ask the community — no account required