Boot problem Stratix Kit EP1S25

Hello,

I'm working on a project where we utilize 2 EP1S25 Stratix Evaluation board.

We have directly connected +5V, +3.3V and +1.5V onto the board

and we have problems at boot, sometimes there's a card where the fpga is not programmed (LED PROG OFF), only LED D8 ON (+3.3V)

do you have this problem yet or not

thanks...

Reply to
Patrick
Loading thread data ...

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.