please i will like to know how a rotary walk behind lawn mower is produced and assembled. I am aMechanical Engineering student . Thanks
rotary walk behind lawn mower
Jul 20, 2004
3 Replies
Gnomes.
Mike
I was going to say elves.
They cast metal, stamp metal, bend metal and they assemble all the bits and pieces.
If you're any good as a Mech E student, you should be able to figure out a logical procedure just by looking at one.
If in doubt, go to a used lawn mower shop, buy one. Tear it down to all the component parts. Then put it back together. If it runs again, you know the answer to your question.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required