AVO b183 LCR Meter

I would presume that Lo and Hi are the test terminals that you connect the unknown inductor, resistor or capacitor to. "G" would be ground for any shielding that may be part of the unknown device or to ground clamps or whatever that might form part of a fixture that would plug into the three terminals.

As an example, a fixture could be made to clamp down surface mount parts, ground would be applied to the hold down clamp.

John

The guard terminal 'G' has the same potential during measuring as th Lo terminal, and is used as a screen. It is for use with screene test leads (not those that are supplied as standard) On high valu inductors and low value capacitors , where capacitance between lead can cause errors, screened leads can be used with the screen connected to the guard circuit. It is also recommended that lo capacitance cable is used

For all other measurements with the two leads supplied, connect th

black test lead to the 'Lo' socket and the red test lead to the 'Hi' socket

Il se trouve que water man a formulé :

Thank you very much :D