Embedded Programming

  1. Home
  2. Embedded Programming
16393 Threads Posts
to

Worth reading in Embedded Programming

Pager call standards

One of the features of a product I'm working on is that ability to call a beeper if there is an equipment problem. At f...
3 comments posted 22yrs
posted by NOSPAMdboland9
3 comments posted 22yrs posted by NOSPAMdboland9

AVR Algorithem Builder

Anyone had good/bad expereiance with using "Algorithem Builder for AVR"? web site http://www.algrom.net/english.html Lo...
1 comments posted 22yrs
posted by rdhopkins
1 comments posted 22yrs posted by rdhopkins

Want to by low cost MPC5xx dev. board

Hi all, Where can I find/buy a low cost MPC5xx, only with an onboard MPC5xx and an onboard BDM connector. I just have to...
0 comments posted 22yrs
posted by laurent.gauch
0 comments posted 22yrs posted by laurent.gauch

AVRISP

I have the AVRISP and when programming the ATMega 8 chip I have 2 chips out of four that have locked up when been repro...
23 comments posted 22yrs
posted by rdhopkins
23 comments posted 22yrs posted by rdhopkins

Controller reset by software?

Hi, Our ADuC842 (8051 family) based prototype has started to behave erratically. We're fairly certain it's a hardware p...
5 comments posted 22yrs
posted by wpsmits
5 comments posted 22yrs posted by wpsmits

how to compile c program

shocking video (approx 5 minutes) analyzing Pentagon attack. Where is the Boeing? http://www.freedomunderground.org/mem...
1 comments posted 22yrs
posted by --
1 comments posted 22yrs posted by --

Infinite loop in PSOS_INIT()

Hi, Problem Summary: While executing the BSP code for our target board (on ARMulator, an ARM instruction set simulator)...
5 comments posted 22yrs
posted by arun.rangasamy
5 comments posted 22yrs posted by arun.rangasamy

OT: Potting compounds

I need to pot some electronics and know nothing about potting. I've looked over several web site of companies that prov...
6 comments posted 22yrs
posted by egadsNOJUNK
6 comments posted 22yrs posted by egadsNOJUNK

Rx Aurel module and Rabbit RCM3700

Hi everyone! I have the following question: I need to interface an rx module RF from Aurel (RX-4M30RR01SF) with a Micro...
1 comments posted 22yrs
posted by follia77
1 comments posted 22yrs posted by follia77

PIC 18 Series - HS+PLL Enabled Clock Mode

Hi I am using a PIC18F452 with an external 8MHz crystal. I am trying to enable the HS+PLL Enabled mode, the device prog...
2 comments posted 22yrs
posted by john.lucas
2 comments posted 22yrs posted by john.lucas

Problem with new ICOP Mity SoC

Hello, Our company has been developing a new product for many months. We have been using Mity SoC (DM&P, ALi M6117D A1,...
0 comments posted 22yrs
posted by vickyBADMAIL
0 comments posted 22yrs posted by vickyBADMAIL

Phytec MPC555

Hey, I have the phyCORE-MPC555 with 1 MB RAM, 512 KB Flash. I would like to store some program variables in this extern...
1 comments posted 22yrs
posted by aakashj
1 comments posted 22yrs posted by aakashj

what can i do with those gpio ?

I'v got a mips SoC running Linux kernel, 16(maybe 32 if i sacrifice some memory) GPIO pins sitting bored (16 can initia...
9 comments posted 22yrs
posted by logistyka1
9 comments posted 22yrs posted by logistyka1