Embedded Programming

AT91SAM7S64 DBGU serial port receiver timeout interrupt

I have a couple of questions I am having trouble getting answers to from the local Atmel FAEs. Our software team is tel...

3 comments posted 20yrs

posted by spamgoeshere4

3 comments posted 20yrs posted by spamgoeshere4

code banking in keil

Hi all! About "code banking" using keil compiler, I read first 32k memory of bank is kept as common area and rest 32k f...

8 comments posted 20yrs

posted by aparna247

8 comments posted 20yrs posted by aparna247

tamper resistant messages on 8051

I need to send short RF messages (approx: 2 bytes) between 8051 devices. How do I make sure that the messages are not t...

9 comments posted 20yrs

posted by pebrian27

9 comments posted 20yrs posted by pebrian27

mc9s12ne64 Trying to enable Interrupt result in "no source reference found" ?

Hi there! I am trying to get my interrupts working on my mc9s12ne64 board. The code is as follows. ####################...

3 comments posted 20yrs

posted by mupptupp

3 comments posted 20yrs posted by mupptupp

facing Problem while writing UART driver

hi. I am writing the keyboard driver (using the UART and RS232 protocol). There is an Receive Fifo And one Flag registe...

4 comments posted 20yrs

posted by chaudhari.rahul.r

4 comments posted 20yrs posted by chaudhari.rahul.r

OT - Streetlight

A small distance from my house is a streetlight. The streetlight has been there as long as my house, about 8 years. In...

30 comments posted 20yrs

posted by jstewart

30 comments posted 20yrs posted by jstewart

Recommend SDLC/HDLC IC

Dear friends, I am looking for a SDLC/HDLC chip that can be interfaced through PCI bus. I found Infinion makes such typ...

0 comments posted 20yrs

posted by digitalsuresh

0 comments posted 20yrs posted by digitalsuresh

Simple gate array to replace 4 ls ttl + eprom

Hi, I have a low power pwm inverter designed back in 1996 which currently uses 4 ls ttl for logic and the first couple...

18 comments posted 20yrs

posted by nospam

18 comments posted 20yrs posted by nospam

Pleas for help from clueless students?

I seem to get a steady trickle of pleas, requests, and demands for help from what appear to be utterly clueless Enginee...

50 comments posted 20yrs

posted by grante

50 comments posted 20yrs posted by grante

PIC usart problem

Hi everyone, I am having a big trouble with my PIC's serial communication. I have codes like these: GPS: CALL set4800 A...

3 comments posted 20yrs

posted by ali.keles

3 comments posted 20yrs posted by ali.keles

HTML Link sensing

I'm a good bit of the way through writing an HTML browser for my system which displays on a 10.4" 640x480 screen and ac...

0 comments posted 20yrs

posted by news

0 comments posted 20yrs posted by news

CANape+CANStress Interface Problems

Dear all we are testing for CAN Mute fault (i.e CAN Mute fault:- Transmission failures are counted modulo n_TxNOK_max i...

2 comments posted 20yrs

posted by maddukuri.rajesh

2 comments posted 20yrs posted by maddukuri.rajesh

How to access Server from web Browser

Hi, I had made a simple web server on VxWorks for the vxSim i.e. the simulator. I have installed the network interface...

1 comments posted 20yrs

posted by nsingh005

1 comments posted 20yrs posted by nsingh005

MC9S12GC pwm problem

Hi to all. I'm new to this processor so I may be doing something dumb here , but I cant get the PWM output to go over 5...

6 comments posted 20yrs

posted by seegoon99

6 comments posted 20yrs posted by seegoon99

MIL-STD-1553 Development Board

Hi all, I am looking for a development board for MIL-STD-1553. I have made an internet research for anything appropriat...

12 comments posted 20yrs

posted by karl-heinz.rossmann

12 comments posted 20yrs posted by karl-heinz.rossmann