Embedded Programming

  1. Home
  2. Embedded Programming
16390 Threads Posts
to

Worth reading in Embedded Programming

Motor info needed

Can anyone point me to a web site for the Dayton that makes electric motors. I've done the Web searches, but all the hi...
3 comments posted 20yrs
posted by mojaveg
3 comments posted 20yrs posted by mojaveg

PC Engine WRAP

Hi, I couldn't found its website. Can anyone please tell me its url? Thanks Sam
0 comments posted 20yrs
posted by sam
0 comments posted 20yrs posted by sam

How do I get current?

All, Finished my MSEE about 7 Yrs ago. Back in my undergrad, I took a course with the Motorola HC6811 E series. My job...
14 comments posted 20yrs
posted by joseph.burgel
14 comments posted 20yrs posted by joseph.burgel

how to use XDATA in Keil uVision?

I can do this in SDCC: xdata at 0xF901 unsigned char port_e; how do I do it in Keil? The help says: "unsigned char xdata...
1 comments posted 20yrs
posted by sdeyoreo
1 comments posted 20yrs posted by sdeyoreo

Problem in sdcc

Hi All, I have a little problem, hope you can help me in this regard. I have this simple program. this is sending the c...
2 comments posted 20yrs
posted by Muhammad
2 comments posted 20yrs posted by Muhammad

Portwell

Hi, I m not sure whether this Portwell hardware is suitable to me. I basically want to build a low power (and low cost)...
0 comments posted 20yrs
posted by fwun
0 comments posted 20yrs posted by fwun

Philips spinning off semiconductor division

I guess they figured if it was good enough for Motorola, it's good enough for them. http://www.reghardware.co.uk/2006/0...
0 comments posted 20yrs
posted by jackklein
0 comments posted 20yrs posted by jackklein

Using JTAG Interface

Dear all, I have seen and used the prototype boards for Blakfin. They have support for JTAG debugging. These boards are...
0 comments posted 20yrs
posted by hs.chauhan
0 comments posted 20yrs posted by hs.chauhan

DMA Broken Up on MPC8248

I am running Linux 2.4 on an MPC8248. In my code, I do many chaining DMAs with chains consisting of a single segment de...
3 comments posted 20yrs
posted by jobhunts02
3 comments posted 20yrs posted by jobhunts02

8051 dead or what?

Hi All. I used Atmel 8051 derivatives in all my earlier projects. Atmel made a really nice chip in the AT89C55 then lat...
16 comments posted 20yrs
posted by noname
16 comments posted 20yrs posted by noname

PAL SIGNAL

I am doing a PAL signal generation project using atmega8.I need to know exact timing chart.ie Where do I give sync pulse...
15 comments posted 20yrs
posted by naveendavisv
15 comments posted 20yrs posted by naveendavisv

c, basic and pascal to ASM translator

Hi, Here is an easy way to build a true MPLAB MPASM project without writing a single line of assembly source code, usin...
0 comments posted 20yrs
posted by noreply
0 comments posted 20yrs posted by noreply

Fault management

1,If all faults that are stored in the fault memory are confirmed faults, the software shall delete the confirmed fault...
4 comments posted 20yrs
posted by maddukuri.rajesh
4 comments posted 20yrs posted by maddukuri.rajesh

test - ignore

ignore this message
3 comments posted 20yrs
posted by ekappos123
3 comments posted 20yrs posted by ekappos123