MIL-STD-1553 RT Addressing

Dec 29, 2006 2 Replies
A

Hi Everyone,



Can anyone tell me, How to set the Remote terminal address for my RT?. Guys we are using DDC-component. The part number is BU65178 G3 290. This IC has pins to set the Address for RT in two ways,



One is Hardwired and another is Software programmable. I am very clear in Hardwired method, but I don`t about software method.



I just want to know whether the bus controller will set the RT address in Software method? If its like that, how it will send the words ( Command or Data ) to set the RT address? I have found in the NOTICE 2 that RT address should be done with the help of external connector. Should we have to go for external connector to set the RT address?



Hope you understand my query, I am awaiting for your reply,



With regards, Anand



Vote
Twitter Facebook LinkedIn
K

Hello Anand,

We were using MIL-STD-1553B long time back and if i remember correctly we have to set some registers (which i don't remember...). But one thing i am definitely sure is we can set the RT address thru the S/W.

Kerri

Anand wrote:

Vote
Twitter Facebook LinkedIn
K

Hello Anand,

We were using MIL-STD-1553B long time back and if i remember correctly we have to set some registers (which i don't remember...). But one thing i am definitely sure is we can set the RT address thru the S/W.

Kerri

Anand wrote:

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required