Looking for Majic JTAG Cable schematic (CA-ARM20 / CK-ARM20)

Jan 06, 2009 2 Replies
A

Hi,



I am looking for a schematic/pinout diagram for the 20-pin arm cable (CA-ARM20 / CK-ARM20) used by this debugger. Does anyone have it? If I am not mistaken it's a simble DB25 to 20-pin header cable. I can't find a pinout for the DB25 connector that connects to the jtag device.



Could anyone do a trace using a multimeter and post a pinout diagram? Please help.



Best regards, Jon


--



--------------------------------- --- -- - Posted with NewsLeecher v3.8 Final Web @

formatting link



------------------- ----- ---- -- -



Vote
Twitter Facebook LinkedIn
N

Jon, I thought the information you need is in app note 10010.pdf. But on checking, it does not show the cable pin out, only the JTAG connecttor pinout. I took one apart and it is hand wired inside the shell. It does not look like a 1 - 1 match either.

Email me direct if you need a copy of the pdf.

Scott

Vote
Twitter Facebook LinkedIn
J

Hi Scott, Thanks for the reply. I think I have seen these documents but I can't find a diagram for t he cable itself. I was hoping someone could take a look inside to trace how it connects in both ends (debugger side and target board side). I can't find a diagram anywhere.

Thanks and regards, Jon

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required