ic-prog => pic16f628a

Sto' usando IC-Prog con il programmatore PicBoy (descritto da FareElettronica di qualche mese fa') e funziona benissimo per programmare i PIC16F84A; perchè allora non funziona con i PIC16F628A? (le piedinature sono pressochè identiche!)

Grazie dell'aiuto. Ciao

Reply to
Andrea
Loading thread data ...

Il giorno Thu, 3 Jun 2004 08:22:13 +0200, "Andrea" ha scritto:

Non conosco il circuito del PicBoy, ma scommetto che il pin 10 (RB4/PGM) non è stato collegato a massa (0V). Il 628 ha un bug, descritto nel "PIC16F62X Silicon/Data Sheet Errata".

Module: Low Voltage Programming Mode The high voltage override for low voltage programming does not operate as specified in the programming specification. In the Low Voltage Programming (LVP) mode, the device can be programmed without using 12V on VPP (pin 4). However, when high voltage programming is used while the part has low voltage programming enabled, the Low Voltage mode is not overridden. If RB4 goes high for any reason during high voltage programming with LVP enabled, the programming will be interrupted.

Work around Pull RB4 (pin 10) to ground during the initial programming to prevent programming interruptions. Once LVP has been disabled, it remedies this issue with RB4.

In parole povere, anche se il modo di programmazione a bassa tensione (LVP) è disabilitato, se il pin RB4/PGM non viene tenuto a livello basso durante la programmazione, può verificarsi un errore.

Reply to
Luigi C.

"Luigi C." ha scritto nel messaggio news: snipped-for-privacy@4ax.com...

i

sono

non è

[cut]

(LVP) è

la

Conosco già questo problema ed infatti lo avevo già messo a massa... Però non cambia nulla! Piuttosto da notare che IC-Prog supporta il 628 ma non il 628A (me ne sono accordo solo questo weekend!); quindi io in realtà ho tentato di programmare un 628A facendo credere a IC-Prog che si trattasse del 628...

Quindi è per questo che non me lo programma?

Reply to
Andrea

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.