contains just the code
for the ride.
sort of thing.
Does it use an actual hard drive, or a solid state drive? The Microdyne RCB2000 telemetry receiver used embedded NT, and a 80 MB MDISK solid state drive. I lost count of how many I formatted and installed in new receivers at the factory. I was surprised when a customer demanded and got an IDE drive installed in another VME based telemetry receiver we built. They didn't like solid state drives for some reason.
I love the LeCroy scopes we have purchaced. We have Mostly the older PPC based models (9 units). The DDA 120/125, LC Series, and Wavepro 960. The deep memory and tons of built in trigger modes are great. We used the math and Jitter packages on them and saved tons of debug time. I cannot talk to the newer models as our budget for new capital is not what it was a few years ago. Tek has caught up a bit but I still think LeCroy has the edge. The only trouble we have had was on the Wavepro 960 the cursor position knob failed, this was easily repaired.
it.
Well, not a problem, just a few flaws. EG Do a megasample trace of some logic signal, then zoom in and pan in time horizontally. The displayed delay in numbers has not sufficient digits. Apparently untested.
Rene
Have something to add? Share your thoughts — no account required.
Ask the community — no account required