60 layer boards?

Nov 20, 2026 Last reply: 1 hour ago 5 Replies

First reply

Bill Sloman

It looks like ignorant alarmism. Multilayer boards tend to have a standard thickness, so they don't use up more resin, glass fibre or copper in their more numerous but thinner layers. My guess is that the 60 layer board are in the printed transformer windings in the power…

Read the full reply

It looks like ignorant alarmism. Multilayer boards tend to have a standard thickness, so they don't use up more resin, glass fibre or copper in their more numerous but thinner layers.

My guess is that the 60 layer board are in the printed transformer windings in the power supplies that down-convert the high voltages supplied to the racks to the higher currents (at around a volt) supplied to the chips on the boards. Printed windings are odd sorts of printed circuit boards, and they are less likely to have a standard thickness.

Lots of data centres are going to need lots of printed circuit boards, and that is going to create a supply crunch, but I suspect that boards themselves are going to be pretty ordinary.

The problem does appear to be real. Prices have increased and there are long lead times even on 8-layer boards. Apparently there are only a few looms worldwide that can make the glass cloth and they are at full capacity. The problem is worst for the better quality grades intended for high-frequency use. John

Imagine trying to do impedance control on a 60-layer board.

John Larkin Highland Tech Glen Canyon Design Center Lunatic Fringe Electronics

At IBM we were shipping 100-layer ceramic TCMs mounted to 24ish layer Clark boards back in the early 80s. All controlled impedance and all ECL except the main memory.

Cheers

Phil Hobbs

A 60-layer PCB might be 300 mils thick, 5 mil average layer spacing, maybe 4 mil dielectrics. Really skinny traces might have managible impedances.

Keep them short. Maybe just some layers could support the longer runs, with non-uniform dielectric stackups.

Saturn refuses to consider it at all.

We've done 12 layers, nasty enough. I'm mostly doing 4 and 6 lately.

Semi-AI layout woud be cool. We'd do the important place and route and let it grunt out the rest.

John Larkin Highland Tech Glen Canyon Design Center Lunatic Fringe Electronics

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required