Hello,
I use Orcad 9 and i have 3 questions :
1 . How can i forbid (in Layout) the autoroute to route a component on the TOP (because i can't weld this component on the TOP)
2 . How can i set a pad to center the tracing paper (in Layout). I don't success to set a pad without to put a component in capture. 3 . How is it possible to set Layout to be able to change the width on the same net during the autorouting. For exemple, the net start with a large width and when the net have to pass between 2 pads very close, the width changes and becomes thin and after become back large.
Thanks very much for answer
Fatango