Electronics Computer-Aided Design

  1. Home
  2. Electronics Computer-Aided Design
1796 Threads Posts
to

Layout Footprint sot23

Hi to everybody! I'm new to this list. I'm trying to learn to use Layout from Cadence and I've to place a component in...
5 comments posted 20yrs
posted by visand.eln
5 comments posted 20yrs posted by visand.eln

hspice parametric analysis

hello could you tell me how to set ac analysis with different load? i use .data directive and then sweep it in ac analy...
0 comments posted 20yrs
posted by jutek13NO_SPAM
0 comments posted 20yrs posted by jutek13NO_SPAM

help needed in coding FIR filter

Hi every one i m doing a project i.e. implementation of FIR filter in Verilog environment ..... for FPGA applications.....
2 comments posted 20yrs
posted by firdaus.jahan
2 comments posted 20yrs posted by firdaus.jahan

Spice Accelerator Hardware?

Dear Friends, I'm very new in using Spice. Is there any accelerator hardware that speeds up the simulation of circuits?...
28 comments posted 20yrs
posted by douglasm
28 comments posted 20yrs posted by douglasm

saving schematic revisions in eagle?

Is there anyway to (semi)automatically save revisions of schematics (and boards) in eagle? thanks - jim ----== Posted v...
1 comments posted 20yrs
posted by jim22
1 comments posted 20yrs posted by jim22

NEC Plasma Power Supply fried

A friend has two large Plasma screens with burned out power supplies. He's a Broadcast Maintenance Engineer at a 24 hou...
1 comments posted 20yrs
posted by otterson
1 comments posted 20yrs posted by otterson

spice libary problem

I have added a library of Tube to Orcad 10.3. I have runned simulation of a my circuit that contain a part of tube libr...
1 comments posted 20yrs
posted by antonix
1 comments posted 20yrs posted by antonix

USB GPIB Controller

EDN had an article in the Design Ideas section for a USB GPIB controller -- the link in EDN is incorrect -- the author e...
0 comments posted 20yrs
posted by jdwalton
0 comments posted 20yrs posted by jdwalton

pspice orcad 9.1 (again)

Is there anyway that I can use 'capture' to place RMS current 'markers' on the circuit? also can i get multiple y axis'...
3 comments posted 20yrs
posted by dindyk
3 comments posted 20yrs posted by dindyk

Data Decoding at 10 Gbit/s

Hi, I would like to design a 16 channel SERDES ASIC in 0.13µm running at 10 Gbit/s per channel. For transmission a stan...
3 comments posted 20yrs
posted by quinn_the_esquimo
3 comments posted 20yrs posted by quinn_the_esquimo

R-L-C structures on PCB

Hi, recently I was assigned with the job to design a Printed Circuit Board (PCB) which does a kind of analog signal for...
22 comments posted 20yrs
posted by quinn_the_esquimo
22 comments posted 20yrs posted by quinn_the_esquimo

request info on RFID uhf reader module

Hi all, I'm trying to get info to realize a custom system. In particulary I need to find and buy a reader module with a...
7 comments posted 20yrs
posted by andrea.dimauro
7 comments posted 20yrs posted by andrea.dimauro

PCB Signal integrity simulation

Hi to all, Looking for PCB Signal integrity simulation software (Hyperlinks Equivalent). Thanks, Y.B.
2 comments posted 20yrs
posted by no
2 comments posted 20yrs posted by no