Just learning how to use OrCAD (from MultiSIM) and was wondering how to use orcad's 8 bit ADC "ADC8Break" part. How do I determine what the pins mean?
The pins in general are IN analog in REF common mode voltage?? AGND analog ground CNVRT ???? STAT ???? OVER ????
Any help apprec.
Monty
Take a look in the documentation (it should have been installed on your hard drive) and look in the PSpice Reference Guide. It will have complete specs on this part, including pin descriptions, timing setup, etc.
Charlie
Monty Hall ha scritto:
I learned by using this sample:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required