hi guys,
got an akai ct2867at 68cm telly that's died, parts that i have found failed are as follows:
q404 q402 q403 d403 r410
these are all in the power supply, anyway, i replaced them & fired it up & basically it blew them up again. before i turned it back on i had checked the horizontal output transistor, & it check out ok, ive been over all the electros in the power supply & around the eht transformer & can find no problem caps.. i'm wondering if the eht transformer might be the culprit? when i fired it up, the led on the front lit up for a few seconds before the smoke got out, so i'm thinking the low voltage supply is ok.. any ideas before i fry another set of power supply components?
cheers,
timbo.