DVD player display panels turned into synchronized Arduino clocks

Nov 18, 2026 Last reply: 28 minutes ago 2 Replies
Jump to replies (2)

The starting idea here is a nice one: rescue the LED display panels from old DVD players and give them a second life as working clocks. Jose Luis Monteiro | Electronics uses three salvaged front panels, each built around a 28-pin SOP driver marked TM1628 or SM1628, and runs all of them from Arduino Uno boards through a solderless breadboard.



The wiring is kept simple and tidy: jumper wires, 220-ohm current-limiting resistors, pushbuttons and status LEDs. Each panel has a four-digit multi-segment LED display with auxiliary media icons, and talks to the Uno over just three control lines: data in, clock and strobe. The close-up work stands out, with solder connections, button readout codes and reverse-engineered bit-to-segment arrays all shown in detail.



What makes this build genuinely instructive is the code structure. A 16 by 2 table titled segHexNumber[16][2] holds the segment data, and the differences between panels live mainly there and in the updateDisplay function. That matters because each salvaged board routes segment lines to digits differently, so every panel needs its own RAM address mapping. Three code versions are presented side by side to highlight those differences, and code for all three models is linked on GitHub, with the datasheets from Shenzhen Titan Micro Electronics shown along the way.



One wrinkle worth noting: TM1628 and SM1628 share pinouts and initialization commands, but one uses two bytes per digit, so code is not drop-in identical across chips. As for an open question, the pushbuttons are on the breadboard, and using them for time adjustment seems like the natural next step, though that has not been shown yet. Watching the three panels count up as synchronized digital clocks is a satisfying payoff.



Project by Jose Luis Monteiro | Electronics. Watch it on their YouTube channel:

formatting link


The way the code is organized is the clever part for me. Keeping the panel differences inside the 16 by 2 table and the updateDisplay function means anyone adapting a fourth panel only has to remap addresses instead of rewriting the sketch. The trade-off is that each salvaged board really does route segments to digits its own way, so there is no single universal mapping. Three code versions side by side makes that comparison painless.

A concrete improvement to suggest: wire the pushbuttons already on the breadboard to set the time directly on each panel. The datasheets specify an 8x2 key matrix in common cathode mode, so the driver hardware supports key scanning. That would turn the displays into clocks you can adjust in place, and it would exercise the button readout codes the maker already documented. Possibly also try one SM1628 panel next to the TM1628 ones to confirm the two-byte-per-digit handling works mixed together.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required