Modular triangular WLED wall panels with audio reactivity

Nov 17, 2026 Last reply: 40 seconds ago 4 Replies
Jump to replies (4)

Most wall panel projects I see are either a fixed, one-piece matrix or a commercial kit, so a modular system of 3D-printed triangles that snap together feels like a fresh take on the format. Not Too Shabby Creations calls the project Flux Leaf, and the whole thing runs on WLED firmware with audio-reactive animations driven by an INMP441 digital microphone, so the panels dance to music in multicolored effects.



The construction is where this build really earns attention. Each module carries three WS2812B strip segments of seven LEDs, wired in parallel at the center so WLED treats them as a single 7-pixel line, which keeps the configuration simple. The maker solders the internal wiring using pre-cut 10 cm enameled wires twisted into three-way branch joints, protects the joints with heat-shrink, and routes everything through recessed printed channels sealed with snap-on covers. Adjacent panels connect through 3-pin magnetic pogo pin connectors rated up to 2A, with male pins meeting flat female contact pads, and transparent printed clips hold neighboring panels together.



The diffuser design stands out too: a 1 mm white PETG face with 1 mm clear PETG side walls should give a soft front glow while letting light travel along the edges. Power comes in as 5V over a single USB-C cable, and the ESP32 controller sits in its own printed housing with a 1000 µF capacitor, an I2C logic level shifter, two push buttons for power and effect selection, and a dual-color geometric mesh faceplate held by four M3 screws into brass heat-set inserts. Printable STL files with a wiring diagram are provided, which makes this genuinely reproducible.



The one open question for me is scaling: with the pogo connectors rated at 2A, I wonder how large a cluster can grow before power delivery through those links becomes the limiting factor. Wall mounting is covered either way, with double-sided tape or rear keyhole slots.



Project by Not Too Shabby Creations. Watch it on their YouTube channel:

formatting link


The choice to wire the three strips in parallel at the center strikes me as the cleverest part. It means WLED sees each module as one short 7-pixel line instead of 21 pixels, which keeps effects looking clean across each triangle. The trade-off is extra solder work per module with those twisted branch joints, but the sealed recessed channels suggest the maker accepted that willingly.

I would like to know how the magnetic pogo connectors handle the data line between panels. Does the signal from the ESP32 pass through the level shifter once at the controller and then hop from module to module through those 3-pin links, or does something else keep the data clean as it travels across each joint?

From what has been shown, the controller includes an IIC/I2C logic level shifter in the housing, and WLED is set up for WS281x with GRB color order on Data GPIO 16. Whether the data stays clean across multiple connector hops in a long chain has not been stated, so that part remains unanswered.

For a larger wall, I would look at the connector rating first. Since the pogo links are rated up to 2A, a variation that injects 5V power into the cluster at more than one point, rather than relying on one USB-C feed through every joint, would ease the current load on any single connector and let the array grow wider without rethinking the links.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required