Electronics Repair

21790 Threads Posts
to

Vizio L32 Power Supply Board

The power supply board on my Vizio L32 LCD TV is not working. I tried fixing it for a while and made some progress, but...
0 comments posted 19yrs
posted by yeomps
0 comments posted 19yrs posted by yeomps

Toshiba 34HF83 lines in pix at startup.

Toshiba M # 34HF83 it's a HDTV, it has horizontal interference lines going accross the pix at startup. the lines get th...
0 comments posted 19yrs
posted by greeben
0 comments posted 19yrs posted by greeben

blown Bob Parker ESR meter.

I wasn't paying attention an tried to get read the ESR on a cap in a hot circuit. Wonder if anyone has made a repair on...
11 comments posted 19yrs
posted by everettcotton
11 comments posted 19yrs posted by everettcotton

Technics SA-EX600 receiver, no output

I've inherited this A/V receiver from a former housemate. The device powers up and all the controls appear to work, but...
0 comments posted 19yrs
posted by idahoev
0 comments posted 19yrs posted by idahoev

Calibration instructions HIOKI 3200 meter..wanted

Approximately 1983 erra. I picked it up at a Value Village, repaired the selector on/off switch now need to calibrate it...
1 comments posted 19yrs
posted by justtis
1 comments posted 19yrs posted by justtis

Cap markings unfamiliar

This is a small (8x3 mm) yellow axial "blob" w/hard (ceramic?) shiny exterior. Markings: FC4 9116 Presume the latter is...
9 comments posted 19yrs
posted by me
9 comments posted 19yrs posted by me

RCA Rear Projetion TV

Our RCA tv is only a year old and the screen went bright red and blinked then the tv shut down. Has anyone had this happ...
1 comments posted 19yrs
posted by Cross9
1 comments posted 19yrs posted by Cross9

GPD-E540 retrace now visible

I have looked for bad capacitors, cold joints, which isn't an issue. I think that it is an automatic adjustment (done at...
0 comments posted 19yrs
posted by mikercana1
0 comments posted 19yrs posted by mikercana1

Datasheet for Pioneer PA2016 motor driver?

This is a 20 pin DIP on the PCB attached to a brushless spindle motor. Any info appreciated, mostly for curiosity. :) T...
0 comments posted 19yrs
posted by sam
0 comments posted 19yrs posted by sam

philips 28pw6517 and 32pw6006

these two sets have similar boards and I am having the same problem with them. I replaced the BU4508dx but the horizont...
1 comments posted 19yrs
posted by patsillah
1 comments posted 19yrs posted by patsillah

SG348

Can someone help me identify and cross reference part SG348, which looks like a dime size disc with 2 legs? It is likel...
1 comments posted 19yrs
posted by maciej.kedziora
1 comments posted 19yrs posted by maciej.kedziora

LCD monitor Bumped

Durring moving, looks like someone bumped my LCD screen, it now has a big "Bruise" in the middle of the screen. I tried...
12 comments posted 19yrs
posted by Riddlebox914
12 comments posted 19yrs posted by Riddlebox914