1. Home
  2. Electronics Repair
  3. Yamaha Stagepas 500, 2009

Yamaha Stagepas 500, 2009

So called R ch went intermittant for ages and now permanently low , not distorted, volume. Swapping over the PA modules shows problem is between wherever the signal is still common and where it is split to L And R in the mixer stage. At least the schema is out there, but anyone been here before. Twizzle sticking shows up no change. Bargraph shows correct output level. Next thing to check after sending this is whether the Monitor Out levels are correct and check the schema for L&R bypass sw and any other switches between mixer and PAs

Reply to
N_Cook
Loading thread data ...

The REC out lines are near enough at master vol pot tops and 2 lines at an interboard connector are near enough at wipers. RECs out much the same but big difference on signal on the other so a failed pot. Got inside and some crud inside. Used by buskers , 500 W this is so rated by Yamaha, they use an 80Ah sports use battery. So a Stagepas would be the most efficient way of gettiing your MegaWatt for carrying your Ah. Some reticulated foam will go inside the air inlet grill , and tell them to keep it clean . I've only previously dealt with PAs of the 300W Stagepas, and again the PAs are a treat to get to in the 500 , mixer of course like any other mixer to get into

Reply to
N_Cook

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.