I have a Toshiba TP50H15 with a power supply shutdown problem, The -18V overcurrent is tripping the sutdown circuit (found some power supply functional detail on the web) I cannot get any fruther without the rest of the schematic. Can you provide any help? Any clues or suggestions would be appreciated.
Thanks very much G. Hamilton
This may help, the G and H were similar in design.
one of your convergance amp ics has gone south these are the large stk ic located on the large heat sink there are to side by side look for
1 or 2 blown resistors and change out the ic's and the blown 2.2 ohm resitors very common problem in projo'sHave something to add? Share your thoughts — no account required.
Ask the community — no account required