It's old but prints very well. The only problem is that most of the time, the main paper feed from the tray jams. I've cleaned the rubber parts as best I can. The paper never seems to make it to the pickup roller after the 180 turn.
Am I forced to use manual feed on this thing? :)
Thanks.
--- sam | Sci.Electronics.Repair FAQ Mirror:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Note: These links are hopefully temporary until we can sort out the excessive traffic on Repairfaq.org.
Important: Anything sent to the email address in the message header above is ignored unless my full name is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.