Jeff,
Actually no I am not. This is for a wall clock timer controlled correcting board. Basically upon a signal from the master clock the clock then adjusts to the right time.
I was thinking of trying a retro fix of board to see if it would work. I realized early on that I would probably not do this, but, I wanted to get opinions on the plus and minus of choices.
Since you put the possible issues the way you did I will totally scratch that idea and move on to other stuff. However, I doubt there would be any major issues at the current draw max of .5 amps. The clock would just stop running!!
Thanks for the detailed typing. All very helpful and informative to my brain antique brain. Learning new stuff is always beneficial.
Thanks again and have a good week.
Les