I have a sharp CF30E50 30" crt TV i was working on for a customer that came in with no Vertical sweep. Soldered it up. Replaced the vertical output chip. ESR'ed in circuit around the chip and did not find anything out of the ordinary. Worked fine for a couple of days and then it took out the vertical output chip again. Any ideas on what could cause this? It looked fine with no picture distortion or compression when it was working.
Bob
----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
formatting link
The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----