I've been trying to discover where the control section for the the heater filaments is. The filaments are not working. Any help would be appreciated. Mark.
RCA CTC 203 Haeter Filaments
May 18, 2005
4 Replies
heater
Please check that CTC203 location L14401's glue is cleaned off; have to unsolder and remove coil, clean off hot glue and clean out the two holes that coil's leads goes through. Reinstall coil & solder normally.
Cheers,
Wizard
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required