Not my usual area of repair but change as good as a rest ,they say Schematic not in the service manual , well not the one on
I've never used one so am unfamiliar. Is the motor function separate from the heater function - I assume so, both are failing to operate it would seem. Unit was working fine and then failed to start one time. LCD and option selections work fine, press Start , the red LED goes on but then no motor or heater and no Err in the LCD display. Fuses and wiring ok, seems to have 2 control lines through the interboard ribbon , one to a relay for the heater and one variable one to a triac for the motor. All associated minor components seem fine testing cold (no isolation Tx here , everything hanging off the mains), no hot spots. Solder to main 64p SMD seems ok. Not full of cooking grime What is a supercap doing on the power board , not connected through the ribbon to the control board, some relay hold-off or hold-on funtion at switch off for some safety reason , rather than memory retention ?