"Gareth Magennis"
** Hope the are willing to supply that for free ??Whole PCBs going leaky is hardly an example of "normal wear and tear".
.... Phil
Orange Rocker 30, combo, 2006
Jun 28, 2010
23 Replies
Er, no they ae not.
Gareth.
Tube sockets and PCBs have always been a problem.
The trick is to bite the bullet and mount the high power tubes on the metal chassis and hand wire them to the rest of the low power stuff on the PCB.
Jeff
?Egotism is the anesthetic that dulls the pain of stupidity.?
Frank Leahy, Head coach, Notre Dame 1941-1954
http://www.stay-connect.com
strange
leakage
forums.
Is there any surface appearance hint? slight crazing/discolouration? would a
1000V / 1Gohm insulation tester show anything and is the conductive path in the bulk or the surface? I've seen this problem with sockets going conductive but that is due to arcing/localised heating and charring so somewhat obviousJoin the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required