Hi All
I have a qty of 3 NEC lcd 1510+ monitors all with the same prob. No picture just a very small clicking noise from near the 12v in socket. Any ideas!!
I know its a bit of a long shot but its worth a try and there is 3 of em.
Thanks rob
The most comon failures these monitors are usually the lamp ballast supply, lamps, and or the the main power supply. These supplies have built in protection, and will cycle off if there are fault. They are normaly replaced as a complete module. NEC will not sell service parts to the end users. Only an authorized NEC service center for their computer monitors can purchase these parts.
Jerry G. ======
The most comon failures these monitors are usually the lamp ballast supply, lamps, and or the the main power supply. These supplies have built in protection, and will cycle off if there are fault. They are normaly replaced as a complete module. NEC will not sell service parts to the end users. Only an authorized NEC service center for their computer monitors can purchase these parts.
Jerry G. ======
The most comon failures these monitors are usually the lamp ballast supply, lamps, and or the the main power supply. These supplies have built in protection, and will cycle off if there are fault. They are normaly replaced as a complete module. NEC will not sell service parts to the end users. Only an authorized NEC service center for their computer monitors can purchase these parts.
Jerry G. ======
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.