I've some problem with the VGA-cable for this monitor... but for to remove the chassis of this monitor i've encountered most difficulties... someone has service-manual with the specifications on how to remove the plastic chassis?
thanx in advance!
If you look at the joint where the back and front of the monitor case meet then you will see two very small regtangular holes on each side of the monitor. this is where the clips that hold the front and back of the case together are located. You will need to find an object that can fit into those holes to push the clips open. Put the monitor face down onto a cusion or similar to avoid scratching the CRT then tilt the monitor to one side by holding the back part of the case. Now when you press something into the holes to push on the clips the weight of the CRT will pull the front case away from the back case. Repeat this process with the other side of the monitor.
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.