This is part of the optical receiver found in various Hewlett Packard metrology lasers.
The HP part number is 1826-0775.
HP references a manufacturer part number of 1DA7Q.
It's a 16 pin DIP dating from the early 1980s.
Any info appreciated.
Thanks!
-- sam | Sci.Electronics.Repair FAQ:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
Didn't find your answer? Ask the community — no account required.
F
Franc Zabkar
On 12 Aug 2009 09:42:50 -0400, snipped-for-privacy@repairfaq.org (Samuel M. Goldwasser) put finger to keyboard and composed:
Could it be a (D)iode (A)rray of 7 diodes???
Does the HP cross-reference include a manufacturer code?
Is the chip powered?
+5V or some other voltage(s)?
- Franc Zabkar
Please remove one \'i\' from my address when replying by email.
S
Samuel M. Goldwasser
No manufacturer. Older schematics simply had the HP part number with no equivalent. Newer ones have the funny 1DA7Q code, which looks like an SMT code but this is a 16DIP.
It's an active device, probably at least one op-amp and comparator. Maybe some AGC circuitry.
It runs on +5 VDC. The main input pins are for an AC signal from a photodiode. These may be an op-amp input and output with feedback components external. There's a TTL output that's the amplified, cleaned up PD signal converted to TTL, and one or two logic signals that say the signal is strong enough. Most of the remaining pins are for bypass caps or
Google is no help, returning either this or a previous unproductive thread on this chip, or the Laser FAQ, where I also ask about it.
Thanks!
-- sam | Sci.Electronics.Repair FAQ:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
S
Samuel M. Goldwasser
Here is a schematic with the part:
formatting link
The pin labeling of the U1 are guesses.
Thanks!
-- sam | Sci.Electronics.Repair FAQ:
formatting link
Repair | Main Table of Contents:
formatting link
+Lasers | Sam's Laser FAQ:
formatting link
| Mirror Sites:
formatting link
Important: Anything sent to the email address in the message header above is ignored unless my full name AND either lasers or electronics is included in the subject line. Or, you can contact me via the Feedback Form in the FAQs.
F
Franc Zabkar
On 12 Aug 2009 19:18:30 -0400, snipped-for-privacy@repairfaq.org (Samuel M. Goldwasser) put finger to keyboard and composed:
FWIW, usbid.com identifies the manufacturer of the 1826-0775 device as NS (National Semiconductor?). I wouldn't trust this info, though.
Is there a patent number on the equipment?
- Franc Zabkar
Please remove one \'i\' from my address when replying by email.
N
N_Cook
photodiode.
external.
converted
enough.
is
in the
Plenty of 4-4 digit type codes , but not that one in
HP OPTOELECTRONIC 1986 HP OPTOELECTRONIC 1982 hp opto 1988
-- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required
Report Content
You are reporting this content to the moderators. They will look at it
ASAP.