Can i safely replace a 470uf 10V cap by a 470uf 25V cap without causing too much draw on the circuit or does the voltage make no difference in needed current? Caps are almost the same size, 10V caps are not available.
Bart Bervoets
Yes.
Graham
It depends on the application, but in most cases you can.
However, it shouldn't be too difficult to get a direct replacement - 10 volt is a stock item with most suppliers.
--
*If PROGRESS is for advancement, what does that make CONGRESS mean?
Dave Plowman dave@davenoise.co.uk London SW
To e-mail, change noise into sound.
Hi Bart Within reason, you can sub caps of the same value but higher working voltage. If you're doing this on the output side of a switch mode PS though, make sure that you are subbing with one of equivalent *type* ie 105 deg low ESR
Arfa
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.