8mm DE-6 chassis out-of-sync - HELP

more detail of problem-symptom please

..the camcorder suffered problems with drum and capstan motors power supplies, problems that have been solved by some recapping. Because of this the mechanical part has gone out-of-sync. I just need some instruction or a copy of the DE-6 service manual. tks. Emanuele.

Still.. what I need is phase info for the mode switch... Emanuele.

I have a DE-6 manual in paper. I'll take a pic. of the mode s/w page and let you know.

here's the link, good luck,

ing

get

GREAT! It is exactly what I needed. Many many many thanks. Emanuele.

te:

ent

ncing

o get

Just a repair brief: camcorder Canon V500 (same as Samsung - SC-L600 L610 L630 L650 VP-L600 L610 L630 L650). Symptoms: not able to play anything. No FF. No REW. Cassette load drawer don't close as expected. No tapi-in action at all. Eject after a manual loading results in bad mech noise and tape loop pending out of the cassette. LCD ok. Loading motor working. Repair: Drum and Capstan motors power lines were always low (0,2V). Recapping C913 and C914 solved all problems. While you are in I would suggest additional recapping as many tantalium SMD's measured high ESR. Expecially 22uF/10V. Resync of the tape deck was possible thank to John providing me a picture of the DE-6 (AD68-30200A) service manual. bye. Emanuele.

Hello, Many years later, I would like to know whether you still have the Canon DE-6 mechanical service manual (gears alignment problem). Thank you