68HC05

Loading thread data ...

Thu May 20 2004 22:55, Peter Sologoubov wrote to All:

PS> В 68HC05B6 (..HС705,..HС805) какая память программ? масочное ПЗУ или PS> перепрограммируемое? Есть ли в этой серии процессоры с УФ электрическим PS> стиранием памяти программ?

Э-э-э... На сайт Моторолки сходить влом, что ли? 705 - EPROM, 805 - EEPROM (флэш) HC05B6/B5 - это уже исторический реликт, можно еще юзать НС05В16 или В32, но они тоже в прошлом. Вся НС05 в общем-то померла, в новых разработках рекомендуется юзать НС08

Пока, Алексей

Reply to
Alex Kouznetsov
Reply to
Peter Sologoubov

Hi Peter,

Fri May 21 2004 22:12, Peter Sologoubov wrote to Alex Kouznetsov:

AK>> HC05B6/B5 - это уже исторический реликт, можно еще юзать HС05В16 или AK>> В32, но они тоже в прошлом. Вся HС05 в общем-то померла, в новых AK>> разработках рекомендуется юзать HС08

PS> А вот заменить умершую старую масочную чем прикажешь?

Флэшовым эквивалентом из НС08

Пока, Алексей

Reply to
Alex Kouznetsov
Reply to
Peter Sologoubov

Hi Peter,

Sun May 23 2004 14:43, Peter Sologoubov wrote to Alex Kouznetsov:

AK>>>> HC05B6/B5 - это уже исторический реликт, можно еще юзать HС05В16 или AK>>>> В32, но они тоже в прошлом. Вся HС05 в общем-то померла, в новых AK>>>> разработках рекомендуется юзать HС08

PS>>> А вот заменить умершую старую масочную чем прикажешь?

AK>> Флэшовым эквивалентом из HС08

PS> Т.е. можно взять определенную HC08 в PLCC52 запрограммировать в нее PS> прошивку от HС05В6 и она будет работать?

Читай аппликуху AN1218, там говорится про совместимость процессорных ядер НС05 и НС08. Она не стопроцентная, но все же высокая:

Motorola's HC05 Family of microcontrollers contains the world's most popular 8-bit microcontroller units (MCUs). In keeping pace with technology and the changing needs of the customer, Motorola has designed the HC08 Family of MCUs. The HC08 Family CPU is a performance extension to the HC05 Family of low cost MCUs. This application note will describe the differences and advantages of the HC08 Family CPU: the CPU08.

CPU08 is fully opcode and object code compatible with the HC05 CPU. Any HC05 code will execute directly on the HC08 without instruction set differences. As this application note will show, there are many improvements to the speed and capability in the CPU08. CPU08 is a faster processor. The basic execution speed of the CPU08 has been increased with advanced high performance CMOS technology. Execution cycles of most instructions have been improved with an advanced computer architecture.

CPU08 has more programming capability. It has more addressing modes, better math support, and much improved data manipulation, accessing, and moving capabilities. Looping and branching instructions have also been optimized.

Насчет периферии врать не буду, не смотрел. Имхо, вряд ли код НС05 прям так сразу заработает на соответствующем НС08, скорей всего ручками придется кой-чего подправить в исходниках. Копай HC908AB32.

Пока, Алексей

Reply to
Alex Kouznetsov

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.