Xilinx XC3S200

23 discussions on ElectronDepot about the Xilinx XC3S200: what owners asked, what went wrong, and what fixed it.

What owners report

Pissed off with Xilinx - Spartan 3

14 week lead time for samples for the XC3S200. How can you prototype with that?It makes worry even more when it comes to manufacture where I might need quantity.

Spartan3 availability

There seems to be some confusion about Spartan3 availability. According to a Xilinx press release in October, several Spartan3 chips should be in production. However, Insight Memec, the UK distributor, has just told me that they haven't any...

JOP on Spartan-3 Starter Kit

I got the Spartan-3 Starter Kit yesterday from Xilinx. This board is areally good bargain: A XC3S200 and 1MB SRAM for just $ 99,-. This boardmakes it hard for guys like Tony Burch or me to sell FPGA boards ;-(Only the Flash is a little bit...

accumulator (again)

Dear All,I'm not an expert in VHDL, i'm just a curious trying to solve aresearch problem with an FPGA.I'm using a 32 bit accumulator in a IP, as part of a SoC project witha microblaze, implemented in a Digilent Spartan-3 SKB ( the FPGA is...

EP1C12 or XC3S400?

Hi,I've seen this prototype board from Altium that seems to have a very good price: comes in two flavours: one with an Altera Cyclone series EP1C12F324C8 and the other one with a Xilinx Spartand 3 XC3S400-4F456C. Both options have the same...

Lattice FPGA

HiI was hoping to get some opinions on Lattice FPGAs compared to Xilinx anAltera. I see they have a SC device out. How does this compare to similadevices from the other two?CheersJon

All discussions