10 discussions on ElectronDepot about the Texas Instruments C2000: what owners asked, what went wrong, and what fixed it.
Hi,I'm trying to counter some pulses (2-10usec width) using the LPC1768Cortex-M3 microcontroller. There are 2 channels on which I have count thepulses on. I have to allow only pulses that are >=2us pulse width (so wecannot simply use the...
Hi everybody,I am searching for a controller with a fast integrated DAC but haven'tbeen able to find anything suitable. Google led me to TIs AM3517 butthis is absolute overkill.I need processing power but not much in terms of interfaces....
Hi:Even though I am able to do what I want with the existing 150MHz TMS320F2812 digital signal controller (DSC), I am always eager to have more speed, since applications that were otherwise inconceivable may become possible if more speed...
Texas Instruments has introduced a new C2000 32-bit microcontroller family:Codenamed Piccolo, it has the performance of a DSP with the ease-of-use of aMicrocontroller architecture. It also has an FPU - not bad!The news article shows a C2000...
I was looking for floating point C2000 DSCs from TI with QFP at Digikey,Farnell, Mouser... And could not find them in stock.. is it common, or justa one time event? How obout others C2000 DCSs?Thank you! ...
Can the a section of the program flash be written to, by the embedded code, for storing things like calibration data that would are loaded serially once the device is in service?I need these to be loaded via the SCI or SPI and written to...