Cypress SL811HS

15 discussions on ElectronDepot about the Cypress SL811HS: what owners asked, what went wrong, and what fixed it.

What owners report

Pen drive - mikrokontroler. Jak to podłączyć?

Czy jest jakiś prosty sposób, by pospolity Pen Drive USB (32MB...1GB) sprząc z mikrokontrolerem np.: PIC 16F84 ?Celem jest przesyłanie co kilka sekund bajtu danych z układu pomiarowego zrealizowanego na PICu do zewnętrznej pamięci,...

Hvordan virker USB porten

Hej NGJeg kan ikke helt forstå hvordan USB portne virker, jeg har søgt lidt pånette, men kunne kun finde at den har 4 ledere, +5V, GND, data+ og data-. Påmange af de andre porte på computeren er der også nogle andre forbindelsertil at...

Cheapest possible host-side USB?

Hi,I'm trying to determine the cheapest possible way to add host-side USB(1.x) to an existing embedded system. So far, the only way I've foundis to use a high-end 32-bit microcontroller. Are there simple...

SL811HS Host Controller

I'm implementing an USB Host using PIC18F452 + SL811HS. The embedded hoscan work properly now with USB Mouse, KB and some other low and full speedevices. The enumeration and data transfer processes are all OK. But the problem occurs when I...

Embedded USB

I'd like to interface a USB mouse to an FPGA. Does anyone have any advice regarding how best to go about doing this. I suspect the use of some form of bridge chip or uC is the way to go but all these seem dominated by the assumption that a...

All discussions