Atmel NGW100

12 discussions on ElectronDepot about the Atmel NGW100: what owners asked, what went wrong, and what fixed it.

What owners report

układem 5V

Witam.W dokumentacji do AT91SAM7xxx piszą że wejścia IO są 5V tollerant, ale nie wolno miec podpiętych pullupów. Niestety przy starcie są podpięte. Nie jest dla mnie jasne wobec tego co wolno:a) wolno miec silne 5V na pinie ale...

NGW100 von Atmel

Hallo,kennt jemand, bezw benutzt jemand das NGW100 Board von Atmel?Irgendwie bekomme ich das JFFS2 nicht darauf zum laufen.Das Image habe ich direkt von Atmel Norway.Ich habe es schon mit SD Karte versucht,über die serielle mit Kermit, und...

Small Linux Box Buying Guide?

Hi,I would like to do some network experimenting and maybe even run a small experimental web server. For this I am trying to find a small box capable of running Linux or BSD, ideally without harddisk and low power consumption (think of a...

Looking for simple board to run linux

I'm looking for something similar to a gumstix board but then moreaffordable. What I need:Smallish board with Ethernet, SPI, GPIO, 3.3VCapable of running a recent linux kernel that has IPv6Free toolchain (gcc)I don't care much about...

AVR AT327000

I've been shown a new dev kit for the AVR AT327000 that uses embeddedlinux and I wanted to get advice and opinions on this processor. I'm notfamiliar with AVR processors at all.I'd like to use the GCC compiler. Is this well supported?Does...

AVR AT327000

I've been shown a new dev kit for the AVR AT327000 that uses embeddedlinux and I wanted to get advice and opinions on this processor. I'm notfamiliar with AVR processors at all.I'd like to use the GCC compiler. Is this well supported?Does...

All discussions