General Electronics

  1. Home
  2. General Electronics
5208 Threads Posts
to

Worth reading in General Electronics

¿ ICD2 ?

Hello: Some URL with schematic and firmware, to build ICD2 ? Thank you.
0 comments posted 23yrs
posted by mmmm
0 comments posted 23yrs posted by mmmm

Re: Electronics Software Question

> Hi all, > > I am a new ( well sort of ) electronics enthusiast and I would like to start > getting into the design an...
0 comments posted 23yrs
posted by heuvelvdgiRemovethiS
0 comments posted 23yrs posted by heuvelvdgiRemovethiS

Can you measure Impedance with an Ohm Meter..

Is it possible to measure Impedance with an ohm meter. For example can you measure the Impedance of a 4 ohm car speaker...
13 comments posted 23yrs
posted by dmrbaptie
13 comments posted 23yrs posted by dmrbaptie

Final Update - Resistor Guide posted

Hey guys, I have finally finished the resistor guide. I knew something was missing... :-] It is posted in alt.binaries....
0 comments posted 23yrs
posted by DarkMatter
0 comments posted 23yrs posted by DarkMatter

Re: Cost of the grid compared to solar

And I suppose that you are going to plunk out 10 to 25 thousands dollars to install this stuff? Or even finance it- wha...
26 comments posted 23yrs
posted by aichipREM
26 comments posted 23yrs posted by aichipREM

Small connector for bicycle battery?

I am looking for some small connectors for my bicycle headlight battery, regulator and bulb lead. They should be as sma...
2 comments posted 23yrs
posted by calbert7
2 comments posted 23yrs posted by calbert7

Ultrafast Temperature Measurement

Hello all, for medical research purposes we are desperately looking for a good method to measure temperature very quick...
5 comments posted 23yrs
posted by roetg
5 comments posted 23yrs posted by roetg

Servo Pack Datasheet inquiries.

Dear, I try to use some servo pack from my used machines for my automation project. But the problem is I have lack of i...
0 comments posted 23yrs
posted by ken25
0 comments posted 23yrs posted by ken25

Need calibration procedure

I hope someone can point me to a source for the calibration procedure for a B&K model 707 tube tester. I've looked thro...
4 comments posted 23yrs
posted by dgmason99
4 comments posted 23yrs posted by dgmason99

DC: mixing 12 and 14 gage

Can I use a 12 gage wire for pos and a 14 gage wire for neg in a 12V dc system? I wonder whether there will be any probl...
2 comments posted 23yrs
posted by newsgroups
2 comments posted 23yrs posted by newsgroups

Re: dc motor control help please

Howdy, Well I have the same motor and I think you may encounter a probably in trying to stop it at specific steps. The...
1 comments posted 23yrs
posted by horizone
1 comments posted 23yrs posted by horizone

OT: WMD Error Msg

Hee-hee! ROTFLMAO! (Please crosspost) 1) Go to Google.com; 2) type in (but don't hit return): "weapons of mass destruct...
0 comments posted 23yrs
posted by alondra101
0 comments posted 23yrs posted by alondra101