rf transceiver

Hi,

Hi,

When you say a transceiver, are you referring to an RF transceiver?

The X10 Powerhouse kind of devices are not transceivers in that sense; they take (receive) RF signals, and transmit X10 signals thru' the mains line, not RF.

So, the small RF circuit you saw is just an RF receiver. The small copper loop is like a coil in the circuit; the main antenna is the external one that is coupled to the PCB thru' the plastic casing.

The circuit for this module is available at

In my experience, it is fairly easy to build an RF transmitter, but the receiver is more complex; its better to buy the receivers, although there again there are circuits available on the internet.

Regards,

Anand Dhuru

Thanks for the link. What I have is a powerhouse x-10 transceiver module and a remote control chain kc674. The circuit that I was describing is in the remote control key chain, so that circuit should be an rf transmitter. If that copper circle is not an antenna, what does a coil do in an rf transmitter?

Here is the link for the device I have;

Adam

Hi,

I thought you were referring to the TM751 / RR501 X10 transceiver; anyway, the actual transmitter in the keychain remote is a design that is pretty much standard to X10 products, and is found with small variations in the 5/6 - in - one remotes, the palm pads, the CM17 Firecracker etc.

The loop, alongwith the copper trace on the PCB acts like an antenna. There are also articles that describe the X10 RF protocol URL'led from Ido's site.

Regards,

Anand Dhuru

I thought it was an antenna too, but am I wrong about the size issue with antennas, shouldn't they be proportional to wavelength, etc, etc. This antenna is only 0.5cm...