reprogram xcf08 serial prom without jtag


Does anyone know if there is an easy way to reprogram xilinx xcf08 serial proms outside of tying the jtag lines to the chip and emulating the whole jtag protocol? Has anyone used jtag successfully to reprogram these proms from the FPGA that they load?

Thanks, Clark

Reply to
Loading thread data ...

Anonymous schrieb:

1) XCFxx is ONLY programmble using JTAG 2) Yes I have success programming XCF over PCI-JTAG bridge in the same FPGA using full custom programming software that programs the XCF08P from .BIT file


formatting link

Reply to

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.