microblaze uclinux ping delay

Hi all, I'm evaluating the porting of uclinux on microblaze. now I'm performing a ping between a laptop PC and microblaze and what I can see is that the averange delay is about 6.8ms... that is a lot of time !.... with a point to point connection I'm expecting less then 1 msec.!

64 bytes from icmp_seq=475 ttl=128 time=6.9 ms 64 bytes from icmp_seq=476 ttl=128 time=6.8 ms 64 bytes from icmp_seq=477 ttl=128 time=6.6 ms 64 bytes from icmp_seq=478 ttl=128 time=6.3 ms 64 bytes from icmp_seq=479 ttl=128 time=6.9 ms

Does anybody has better performance?

Thanks in advance, Francesco

Reply to
Loading thread data ...

Sorry I not tried but I would like to buy the same board (I sow in other post you are using an ml403) and play with the ethernet...

If your laptop is linux... you can try ping -f and after a while if you interrupt (Ctrl-c) you can see some other statistics. If your screen fill with dots during the ping then there are very poor performances and/or some cable problem and/or some negotiation problem....


Reply to

ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.