Our group recently picked up a used Plasma Spray Gun. While it appears to be in very good condition, it is old and no longer supported by the maker. We'd like to get any possible information on it so that we can get the best possible use out of it without damaging it thru misuse.
Here's what we have:
Sulzer Metco Plasma Spray gun and controller
Control unit is a type MCN, Model 836.
Powder Dispenser is a type 4MP, Model DM79158528
Sulzer Metco is now a subsidiary of Perkin Elmer, but I don't think this was the case when these parts were made.
We're specifically looking for copies of the Operation and Parts/Service Manuals, but any information will be better than what we have now, which is zip.
Any and all comments will be appreciated.
thanks,
-
----------------------------------------------- Jim Adney snipped-for-privacy@vwtype3.org Madison, WI 53711 USA
-----------------------------------------------