I am trying to use a spectrum analyzer to measure WLAN OFDM signal. However, I can only see slices of the 20MHz OFDM signal instead of the whole 20MHz span. Do I need a special setting (RBW, sweep time) in order to see the whole 20MHz span?
Thanks.
The analyzer's sweep time is not matched to the OFDM changes, so you only see those portions where the signal happens to coincide (in time) with the SA's own instantaneous tuned frequency . Sweep with Max Hold will build up the peak envelope over many sweeps. But you won't be able to discern much detail about the modulation that way. And noise spikes will be "remembered" along with signal, so the amplitude may appear higher than it actually is.
Are you using an amplifier ahead of the SA, to reduce its effective noise figure and increase your dynamic range?
Steve
ElectronDepot website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.