Embedded Programming

  1. Home
  2. Embedded Programming
16390 Threads Posts
to

Worth reading in Embedded Programming

port u-boot to x86 based board?

u-boot is primarily PPC ARM based, but u-boot information on x86 based board is few, and if i want to port u-boot to x86...
0 comments posted 20yrs
posted by karl121212
0 comments posted 20yrs posted by karl121212

ADuC7022 - 13 GPIOs or 15?

When I look at the current data sheet, it says in the selection table that the 7022 only has 13 GPIOs. But I count 16 o...
2 comments posted 20yrs
posted by spamgoeshere4
2 comments posted 20yrs posted by spamgoeshere4

Starting with the MC68HC908JB8

Hi, Because of the FX1 from Cypress is hard to get for me at this place on earth, I was looking for an alternative and...
3 comments posted 20yrs
posted by gearloose1
3 comments posted 20yrs posted by gearloose1

Re: The monthly Microsoft recruiterspam

>>I recruit for W2 Contract opportunities onsite at Microsoft in >>Redmond, WA. Looking at your resume, I think you wou...
2 comments posted 20yrs
posted by pfarrell
2 comments posted 20yrs posted by pfarrell

Four free Z80 appliances (USA)

Cleaning out my closets, I found four Cidco (Earthlink) MailStation 120 Internet appliances. These are free to the firs...
0 comments posted 20yrs
posted by zwsdotcom
0 comments posted 20yrs posted by zwsdotcom

Basic doubt about 8051 variants...

Hi, I have this basic doubt about the terminology of 8051 variants. I have read a couple of their data sheets and based...
6 comments posted 20yrs
posted by noone
6 comments posted 20yrs posted by noone

port gcc for c51 step by step

Hi, Please help me. Send me same info how to port gcc for c51 step by step. What i have to change in files in gcc to do...
32 comments posted 20yrs
posted by olowski
32 comments posted 20yrs posted by olowski

Using PHY of lan9115-md

I am having some trouble using PHY of LAN9115-md. I cant acess the PH registers through the MAC.I've read the datasheet...
1 comments posted 20yrs
posted by gabrielclimber
1 comments posted 20yrs posted by gabrielclimber

TMS470 and gigabit ethernet controller

I'v to use a TMS470 processor in my application which has to support 2 gigabit ethernet ports. As the TMS470 doesnt hav...
7 comments posted 20yrs
posted by lagidikalyani
7 comments posted 20yrs posted by lagidikalyani

RS485

As we know In RS485 we can connect 32 nodes.,I have one doubt in RS48 Standard we can use upto 4000ft (distance)...will...
1 comments posted 20yrs
posted by jjvijay55
1 comments posted 20yrs posted by jjvijay55

Lists of SPI interface paripheral chips?

As a follow on to my previous message about building sensors around the MSP430 chip, I'm curious if anybody has a good...
6 comments posted 20yrs
posted by dave
6 comments posted 20yrs posted by dave

MMU handling page-fault in embedded RTOS system

Hi all, I am new to this forum. anyone here has experience working with an MMU which handles page-fault in RTOS embedde...
4 comments posted 20yrs
posted by MajorSoul
4 comments posted 20yrs posted by MajorSoul

Low quantities source for AMIS transceivers?

I'm interested in coupling an AMIS-52000 or AMIS-53000 low power transceiver to an MSP430 microcontroller to build a ti...
0 comments posted 20yrs
posted by dave
0 comments posted 20yrs posted by dave

little thing

Hi, I am searching a small sbc with 2 serial (485,422 better) and 1 ethernet, running uclinux or linux, smaller ther be...
0 comments posted 20yrs
posted by iamamug
0 comments posted 20yrs posted by iamamug